Summers Superchisel - 5-Section Manual do Utilizador descarregar pdf (Página 23)

2-11

SECTION 2 – SET-UP OF PART 1 WING

NOTE: Drawings for steps 9 through 17 is on previous page.

9. Install gauge wheel support (8T4090) onto wing with 7/8 x 2-1/2” bolts.

NOTE: STEPS 10 THROUGH 14 MAY HAVE BEEN PRE-ASSEMBLED AT FACTORY

10. Apply anti-seize to jack bolt (8T6000) threads. Screw jack bolt into axle holder (8T4094) far

enough to see hole on bottom of bolt through hole in axle holder.

– Insert 3/16 x 2” roll pin. Insert pin far enough so it will clear tube when rotated.

11. Place gauge wheel depth decal on axle holder.

– Locate decal 1” from bottom of 4 x 4 tube.

– Make sure that decal faces the front of the machine.

– Attach decal off to one side of axle holder to avoid seam on support tube.

12. Slide axle holder and jack bolt into gauge wheel support. Slide 1-1/4” at washer onto bolt and

turn 1-1/4” slotted nut on.

– Do not tighten slotted nut.

13. Add gauge wheel screw top onto jack bolt.

– Insert 1/2 x 2-1/4” bolt into screw top and bolt. Secure with locknut.

14. Attach gauge wheel jack handle to screw top.

– Install 3/8 x 2” bolt in handle and screw top. Secure with locknut.

– Do not over tighten. Handle must pivot freely.

15. Check free operation of gauge wheel assembly.

– Loosen or tighten slotted nut for optimum performance of gauge wheel.

– Install 3/16” x 2” roll pin after slotted nut is adjusted properly.

15a. Adjust clearance between 8T4090 and 8T4094 with 3/4” set bolts and jam nuts.

16. Install 8K1100 (6 bolt) axle and hub assembly into each receiver tube. Apply good quality anti-seize

to axles before installation. Retain axle into receiver tube with 1/2x3-3/4” bolt and locknut.

17. Attach 11L x 15 wheel to hub with 9/16” wheel bolts (torque required: 122 ft-lbs).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 97 98

Sem comentários

Summers Superchisel - 5-Section Manual do Utilizador Página 23